Wireless Vertical Angle Motion Detector

Detector Overview
Placed in the middle of the wall or above a window, the detector will pick up any movement that breaks the beam. Nothing above or below the narrow beam will set it off.

Motion detectors are used to detect un-authorized motion in a particular area of your home. This vertical angle motion detector can be placed four feet off the floor in a horizontal position to ignore any movement under it's beam. This will allow for larger pets to walk under the beam.

Coverage
Detector shoots a narrow beam extending outward 30 ft and extending 10 feet left and right. The beam fans out in a 90 degree angle.

Pet Friendly
This detector is not pet immune. It is recommended that you mount it at a height you are sure your pet is not going to get to. Mount the detector on the wall and turn it horizontally so that it shoots a horizontal beam instead of a vertical one.  

Home/Away Arming Modes
In your alarm system's "away" mode setting, the detector will be triggered by movement in the rooms that you want covered. In the "home/stay" mode, it will pick up movement but will not signal the alarm system allowing you to roam the residence freely.

Installation
A mounting bracket with a ball joint slides into the back of the detector. This allows you to angle the detector in pretty much any direction you want. It is screwed into the wall with the included hardware.
 
-- Detector Specifications --
Battery: 2x AA
Battery Life: 1 Year
Antenna Range: 250 ft. – 450 ft.
Frequency: 433mhz
Encryption: 36 Data-Digit
Current: 15uA
Best Working Temperature: 14°F – 122°F

-- Detector Dimensions --
Sensor: 3.54 x 1.97 x 1.57 inches (8.99 x 5.00 x 3.99 cm)

-- Compatibility --
STS-407, STS-408, STS-410, STS-411, STS-412, STS-415, STS-420, STS-421, STS-450, STS-451, STS-455